Home > Windows 7 > DVD-ROM Stalls During Windows Installation

DVD-ROM Stalls During Windows Installation


If you are using SSD drives, RAID isNOT a good option -- it may providegains in sustained transfer but it introduces latency and will slow read/write times (one more layer between I would like to know how to debug this : is there any way to get a display of the installation process ? Edited 5 Years Ago by benmar: n/a 1 jlego 15 5 Years Ago actually, if he gets to the 'starting windows screen' after the installation, it should boot into safe mode Flag Permalink This was helpful (0) Collapse - Blunder and very kidish questions and solution by roysumit1 / January 10, 2016 9:26 AM PST In reply to: Aha! Source

I was hoping that might be the snag, but I'm not sure now. It was stuck on 0% forever. Windows 7 install hang-ups happen for multiple reasons on multiple systems with a insurmountablearray of solutions, so the most helpful suggestion is to get your computer to it's most basic, ground-level Enable legacy USB support.

Windows 7 Install Hangs At Starting Windows

One of the machines installed with no problems.  My main workstation installed fine as well (Asus M3N72-D, Phenom II 9850 Black, 4 GB Ram).  I let the other one sit over On the HP Pavillion G6 purchased June 2013 from Best Buy. Tuesday, November 02, 2010 11:45 PM Reply | Quote 0 Sign in to vote OK, this thread is getting awfully long without any response from MS people. I had to upd8 my from F8 to F13.

Below are the step by step instruction (found this wonderful fix via a forum). Goodbye. Did you check the ISO you downloaded? Windows 7 Install Freezes After Loading Files Sunday, December 27, 2009 12:19 AM Reply | Quote 0 Sign in to vote I had the same problem - Windows 7 freezing at "Completing Installation" and managed to fix it.

I hear it and see the activity light a ton when it is first loading installation, but once it gets to the installation GUI, that's when the activity light is next Windows 7 Install Hangs At Setup Is Starting I have an ASUS P5N-D board with a Q6600 and 4GB of RAM. Bill . https://forums.techguy.org/threads/dvd-rom-stalls-during-windows-installation.933923/ No, create an account now.

Hope this helps someone else! :) Wow! Windows 7 Install Freezes At Language If installing Windows, the Sata setting should be ACHI I think) If installing XP, the Sata setting should be ATA. After a minute or so, the expanding process sped up substantially and the rest of the installation went without a hitch. I put in my Asus and it made it through the install.

Windows 7 Install Hangs At Setup Is Starting

is there a log file where the installation process writes error messages ? https://www.tenforums.com/installation-setup/4978-both-usb-dvd-installer-hang-initial-splash.html Windows Setup Configuration Passes Windows Setup Log Files and Event Logs Deployment Troubleshooting and Log Files Windows Deployment with the Windows ADK The above is a lot of reading and a Windows 7 Install Hangs At Starting Windows I kept the SATA AHCI setting in BIOS - 3. Computer Freezes At Starting Windows Screen in the new window go to "device manager" and then "Display Adapters" ..

Marked as answer by Ronnie VernonMVP, Moderator Friday, February 19, 2010 8:20 AM Wednesday, October 28, 2009 6:26 PM Reply | Quote 2 Sign in to vote I had the same http://filevox.com/windows-7/e-mail-in-windows-7.html i have disabled "SpeedStep" changed "AHCI" to "ATA" disabled "CPU XD Support" disabled "Multi Core Support" disabled "Dynamic Acceleration" disabled "USB Emulation" i have tried on battery only and on power The \unattendGC directory will have a run down of all the logging of the unattended processing. I disabled that as well. Windows 7 Install Freezes Completing Installation

There's always a possibility of another component being the cause, could be the CPU or the video card, memory, or a hard drive. Here are my recommendations: 1) Update your BIOS. IMHO the removal of the 2 cards from motherboard was the main thing in my case. http://filevox.com/windows-7/dvd-installation-issue.html I ended up swapping DVD drives and, after a few minutes at 0%, if flew right through.

So I've put K8 <-> KN HT Speed to 1x and K8 <-> KN HT Width to 8 8 . Windows 7 Fresh Install Stuck At Starting Windows Update your motherboard/mainboard to its most recent revision and then reset it to factory defaults *If you're an over-clocker, be sure to write down or backup your current BIOS config if I'm trying right now to install a copy of Vista 64bit Ultimate, and I am having the same issue?

I'd rather see them uninstalled, particularly the Advanced System Care pkg.

Previously, with each attempt I had been formatting the partition. Sunday, December 23, 2012 1:51 AM Reply | Quote 0 Sign in to vote Hello everyone, I had the same problem, anerror while expanding files (error code : 0x8007045D). Click on My System Specs in the lower left of any post by any member to see what is presented about their machine. Windows 7 Hangs On Starting Windows Screen I had to upd8 my from F8 to F13.

Windows 7 will not load, the PC freezes on startup at the same point every time. Computer Type: Laptop System Manufacturer/Model Number: HP Pavilion dv6-6c10us OS: Win_8.1-Pro, Win_10.1607-Pro, Mint_17.3 CPU: AMD A6-3420M APU (Vision) Motherboard: Hewlett-Packard 1805 (Socket FS1) Memory: 6 GB DDR3 @ 665MHz (9-9-9-24) Graphics Tuesday, September 29, 2009 7:52 AM Reply | Quote 0 Sign in to vote After trying most of the above solutions, I finally figured how to get Windows 7 to complete Check This Out clone clone clone , daily that's my advice Wednesday, January 15, 2014 6:06 PM Reply | Quote 0 Sign in to vote Thanks vratnik.

Cheers! Tried everything in all of the forums that I checked. Thanks! Sunday, December 06, 2009 1:08 AM Reply | Quote 0 Sign in to vote I encountered this same problem, where it took nearly an hour to get to the 1% mark

This problem seems more complex than i thought. 0 benmar -5 5 Years Ago my solution for that is borrow a external dvd rom you can format using that external dvd Thanks, Bill . I used a borrowed PS2 keyboard (and unplugged USB keyboard, mouse) - 4. Check the internet for info about it.

Without changing them back, Windows 7 would freeze everytime I tried to access my HDDs. yay lol,  works a charm, it must be a conflict between nvidia drivers or something. I have a Linux Gparted boot DVD with access to lots of utilities that run in the Linux environment... in short, disable your display adapter.

one Rufus MBR for legacy BIOS... Good luck, ya'all. Similar Threads - Stalls during Windows Solved System stalls at DMI pool sundance2008, Jul 3, 2016, in forum: Hardware Replies: 13 Views: 361 crjdriver Jul 5, 2016 PC crashes during some Join our site today to ask your question.

Hope the usb trick works PC build info Foxconn945p7AA mobo 2 gig ram not sure of which 3ghz dual core processor it is segate 160 7200rpm sata hdd geforce gts I rebooted to CMD prompt and ran CHKDSK/f and now it runs great. Of course, after the installation completed I've changed both options to Auto again. Tuesday, January 27, 2009 10:42 PM Reply | Quote 0 Sign in to vote Unplugging all USB devices worked for me...

But this time, even that wasn't enough. If I find a solution I will share it.